Z3 Technology Z3-DM8168-APP-41, Быстрый старт

Страница: 8 / 12

CONFIDENTIAL Z3-DM8168-APP-41
___________________________________________________________________________________________
V1.00
Z3 Technology, LLC ♦ 4701 Innovation Drive CB103 ♦ Lincoln, NE 68521 USA ♦ +1.402.323.0702
8

Insert the USB mass storage device.

Repeat the command “
cat /proc/partitions
”

Verify that the partitions present on the USB device are present in the list.

If the partition(s) on the USB media are formatted OK, then Linux should automatically mount the
volume and make it available for use. Usually Linux will mount storage devices at /media/sda1.

Enter the command “
ls –l /media/sda1
” and check to see if the files present in the USB device
are listed.
If not, the most probable cause is that the USB device is not formatted correctly. Re-format the USB
device and repeat the procedure.

Unmount the device by entering the command “
umount /media/sda1
” and remove power.
4.4 SATA interface

Remove the DC power plug from the DC power jack of the Z3-DM8168-APP-41.

Remove any USB devices from the USB jack.

Connect a SATA cable between the SATA jack of the DM8168-APP-41 board and the SATA disk drive.

Connect and turn on power to the SATA disk drive.

Follow the procedure specified by section 4.2 above to turn on the system and obtain a shell prompt.

Issue a command “
cat /proc/partitions
”.

Verify that the partitions present on the SATA device are present in the list.

If the partition(s) on the SATA media are formatted OK, then Linux should automatically mount the
volume and make it available for use. Usually Linux will mount storage devices at /media/sda1.

Enter the command “
ls –l /media/sda1
” and check to see if the files present in the SATA device
are listed.
If not, the most probable cause is that the USB device is not formatted correctly. Re-format the USB
device and repeat the procedure.

Unmount the device by entering the command “
umount /media/sda1
” and remove power.
4.5 Ethernet interface
This test verifies that the Ethernet interface is functional by testing whether the Z3-DM1868-APP-41 can see
the network interface of the PC.

Connect the Ethernet patch cable from the RJ-45 jack of the Z3-DM8168-APP-41 to the Windows PC.

Follow the procedure specified by section 4.2 above to turn on the system and obtain a shell prompt.

Verify that the link LED on the Ethernet jack is lit, indicating that a link is established.