FV2K-1XA User Guide
DOC-USR-0262-05
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
16
(7)
By default, the system will have automatically started encoding. Click on the CH1 tab for channel
one configuration settings. If the encoder status message in the bottom right corner of the screen
shows
RUNNING
, you will need to click the
stop
or
Stop All
button in order to change any settings.
5.2
Thermal Camera Configuration
Go to the System Set-up tab. Use the FPGA option to configure a thermal camera.
Figure 8 FPGA Configuration
(1)
Select Tau2 for Digital video from the Flir® Tau2 or Boson for Boson support
(2)
Select Tamarisk for Digital video from the DRS Tamarisk®
(3)
Select Composite if Analog or NTSC/PAL video from Flir® Tau2, DRS Tamarisk®, or another composite
video output
NOTE:
For thermal camera setting requirements and additional encoder control options refer to the (FV2K, FV4K
and FSDI System Guide).
6.0
STREAMING CONTROL
This section gives step-by-step instructions on setting the FV2K-1XA to output and stream video using each
of the output format options: UDP, RTP, RTSP and RTMP. In addition to the FV2K-1XA, a Windows PC with the
VLC media player
3
downloaded or a hardware decoder. . Please see Section 9.0, Decode Options, for more
information on compatible decoders and PC configuration and requirements for H.265/HEVC decode at HD
3
VLC is an open source media player from the VideoLAN organization that can be downloaded for free online.
