BLD265-SC2 User Guide
DOC-USR-0219-03
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
8
3.0
GETTING STARTED WITH THE BLD265-SC2
3.1
Connecting to the BLD265-SC2
The BLD265-SC2 uses a modern HTML5-embedded Web server for user configuration. Users can connect
to the Z3 device via Gigabit Ethernet (GigE) port. The factory default IP is 192.168.0.59.
4.0
QUICK START GUIDE
4.1
If you have received a system from Z3 with Software Preloaded
To start working with the decoder, you can go straight to Section
Error! Reference source not found.
, “
GETTING STARTED WITH THE BLD265-SC2,” on page 8. This section describes how to quickly generate a
UDP, RTP, RTSP or RTMP stream over IP. Information is also provided on how to change bitrate
dynamically, how to adjust the UDP TS rate, tuning for latency, streaming in multiple resolutions,
recording to USB and utilizing various features including MPTS, closed captioning and forward error
correction.
4.2
If You Already have a System from Z3 and Need to Update the Firmware
You can update the firmware via the HTTP-based user interface by following the instructions in Section
11.1: “Making a Firmware Update”, on page 16.
*Note:
Actual version numbers for your Z3 product may differ from those pictured in this document.
4.3
Access the User Interface using ZFinder
ZFinder is a PC Utility that allows you to find any Z3 Technology product on your network. If you have
not downloaded this to your computer, you can find it on the USB drive provided with your system.
(1)
Verify your PC is on the same network. If you are not in the same network, your device will appear
in red in Z-Finder or Z-Finder may not be able to find your device.
(2)
Run the “ZFinder” PC Utility on your Windows PC. The ZFinder window appears. ZFinder completes a
scan of the network and lists the location of all Z3 systems connected to the network. In this case,
the Z3-DME-20 appears.
(3)
Click on the BLD265-SC2 entry in the window to select it. This will cause the “Edit Device”, “Open
Device” and “Flash LEDs” boxes to activate.
