1
SD-100Z
Z-Wave Door/Window Sensor
The SD-100Z is a Z-Wave
TM
enabled device and is fully compatible with any
Z-Wave
TM
enabled network. It is designed to work with Z-Wave
TM
enabled devices
from any manufacturer. Inclusion of the SD-100Z with STC-100/300 Scenario Hub
allows remote turn-on of appliance when the SD-100Z is triggered.
Adding to Z-Wave
TM
Network
In the rear casing, there is a tamper switch which is used to carry out inclusion,
exclusion or association. Turn the Scenario Hub or Z-Wave Controller into inclusion /
exclusion mode, press the tamper switch on the SD-100Z to complete the
inclusion/exclusion process. The SD-100Z supports one association group with five
nodes. This has the effect that when the SD-100Z is trigger, all devices associated
with it will be operated.
The SD-100Z
will stay “awake” for ten minutes when changing the status of tamper
switch from being pressed to be released or from being released to be pressed to
allow time for configuration.
Choosing A Mounting Location
The SD-100Z is suitable for mounting in dry interior locations only.
Decide which doors/windows are to be protected by the SD-100Z (usually the front
and back doors as a minimum). Additional sensors may also be required for other
doors or windows, (e.g. garage, patio/conservatory doors etc).
Note
: Take care when fixing the SD-100Z to a metal frame, or mounting within 1m of
metalwork (i.e. radiators, water pipes, etc) as this could affect the wireless
transmission range of the device. It is suggested to place the magnet and the sensor
away from the metal surface using a plastic or wooden spacer to achieve the
required transmission coverage.
Installation
1. Remove the fixing screw from the bottom edge of the Sensor. Open the rear
cover.
2. Insert three 1.5V AAA batteries to the battery compartment.
Note
: The adoption of alkaline battery is highly recommended, as it would last for
longer period.
3. By releasing the tamper switch of the Sensor, detach or close the magnet
from the Sensor, the LED on the Sensor will illuminate.
4. Using the rear cover as a template, mark the positions of fixing holes on the fixed
part of the frame along the opening edge opposite the hinges using screws
provided.
5. Refit the Sensor to the rear cover and secure with the fixing screw supplied. Do
not over tighten the fixing screws as this may distort or damage the casing.
6. Fit the Magnet to the moving part of the door/window opposite the Sensor using
the adhesive tape or 19mm fixing screws.
Ensure that the parallel gap between the Magnet and Sensor is less than 10mm
and that the matching line on the Magnet is pointing towards and aligned with the
line on the Sensor.
Tamper Switch
