YZ Systems Milton Roy • 201 Ivyland Road • Ivyland, Pennsylvania • USA • 18974 • P: 281.362.6500 • www.yzsystems.com
Page 13
NJEX 610G / 610F ver.11-2023
Section 5: Programming the Z-100 Controller
Using The Z-100 Controller:
The Z-100 user interface has been designed for
easy navigation and setting of parameters.
The following sections outline the various screens
and the steps needed to change and save settings.
Menu Screens:
To navigate to a Menu or Sub Menu screen, use
the navigation switch and push up or down to high-
light the desired option. The selected option will be
highlighted with an asterisk to the left. To open that
menu item and press the navigation switch. Note
the instructions on the bottom row of the screen for
additional information or how to navigate back to
the previous screen.
Modifying Controller Settings: Z-100 Controller set-
tings will either be a value that must be changed,
an item selected from a list, or a multiple-choice
parameter option.
For items requiring a number to be edited, like the
odorant density below, each digit will need to be
changed individually. Note the arrow underneath
the digit that is currently being edited. Press the
left or right arrow to change which digit is updated.
To change the value, press the navigation switch
up or down. Move to the next digit as needed. To
cancel the change, navigate to the back button and
Press enter on the navigation switch to go back to
the previous screen. To save the change, navigate
to the Save option and Press enter on the naviga-
tion switch to save.
For an item that must be selected from a menu such
as the pump spacer, the option that is currently
selected will be shown with a dash next to it on the
left. To change the selection, use the navigation
switch and move up and down to the desired op-
tion. The possible selection will be shown with an
asterisk to the left. Press the navigation switch to
confirm the selected option.
Lastly, for the alarm sources, you can select multiple
options to turn on or off each alarm source. The
alarms will be shown with a dash next to it to indi-
cate the alarm is active. The activate or deactivate
an alarm, press the navigation switch up or down
to the desired alarm source, the elected alarm will
have an asterisk to the left. Press the navigation
switch to enable or disable the alarm, if disabled
the dash will be removed.