YZ Systems NJEX 6300G, Инструкция и руководство по эксплуатации, Страница: 30 / 128

YZ Systems Milton Roy • 201 Ivyland Road • Ivyland, Pennsylvania • USA • 18974 • P: 281.362.6500 • www.yzsystems.com
Page 20 NJEX EUR ver. 08-2021
Section 4: System Control & Electronics
To Power Up The System
Open the N-300G Controller Enclosure,
figure 19,
and
find the toggle switch S1 located just below center on
the right side of the Printed Circuit Board – PCB. Turn
on the main power switch by toggling the switch to up
position.
Once powered-up, the menu sequence,
figure 20,
will appear. Follow the menu instructions on the LCD
screen as they are presented.
Check to ensure the serial number and model type
shown match the serial number and model type on the
left side of the electronics enclosure and on the inside
of mechanical enclosure door.
See figures 21, 22 &
23.
Next you may have the option of accepting a set of
Pre-Configured operating parameters, that have been
programmed into the Sentry Module,
figure 24.
This
option will only come up if it has been set up in Sentry
and not previously uploaded.
Record the version x.xx number, figure 25, in the For
the Record Form located on Page 114 in Appendix
C: Forms
of this manual for future reference.
IMPORTANT:
If the serial number, model type, or the verometer tag
number do not match the corresponding numbers in
the N-300G controller consult the factory before pro-
ceeding further.
S1
Serial Number
20000
Model Type
7300GE
Display Contrast Adj
50% 22C
Verometer Calibrate
154.20 Calibrate cc
Pre-Configure Parms?
*Yes *No
N300GE Ver 1.02
--NJEX--
pmp bat vmtr sig tnk
PropFlow Idle
*Strt *Dsp *Set
pmp bat vmtr sig tnk
PropFlow Idle
*Stop *Dsp *Set
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25