YZ Systems DynaPak DP-2010JF, Инструкция и руководство по эксплуатации

Страница: 50 / 64

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 44
DP-2010JF ver.05202005
SSSSS
ECTION ECTION
ECTION ECTION ECTION
11: 11:
11: 11:
11: S S
S S
S
Y YY
YYSTEM
STEM
STEM STEM STEM
TTTTT
R RR
RROUBLESHOO
OUBLESHOO
OUBLESHOO OUBLESHOO OUBLESHOOTING
TING
TING TING TING
3. Unscrew the thumbscrews and
remove the six position terminal strip
and cover. This will expose the battery
pack and the three position configura-
tion jumper (located in the lower right
corner of the Z-65 controller assem-
bly).
4. Set the configuration jumper to the far
right position marked stroke indicator
test, figure 44.
5. This will cause all six digits to become
active on the stroke counter. Depress
the reset. The stroke counter should
increment 000000, 111111, etc., up to
999999 each time the solenoid fires.
When the counter display reads
999999, the test is complete.
Timer Range Setting
There are two Z-65 models:
the Z-65/6.1 and Z-65/6.03. Each
Z-65 timer has two ranges for the
timer setting dials.
1. Z-65/6.1 Range Setting:
xx minutes: set the configura-
tion jumper to the far left posi-
tion (factory setting), figure 45.
x.x minutes: set the configura-
tion jumper to the center posi-
tion, figure 46.
12.3 d - Jumper switch location
Approved
Factory
System
figure 44
factory positioned
for 1 - 99 counts (xx)
Jumper switch location
Jumper switch location
for .1 - 9.9 counts (x.x)
Mutual
System
Approved
Factory
Mutual
System
Approved
Factory
IMPOR IMPOR
IMPOR IMPOR
IMPORTTTTTANT NO ANT NO
ANT NO ANT NO
ANT NOTE: TE:
TE: TE:
TE:
When the test is complete, move the jumper back
to the factory position (far left position).
IMPOR IMPOR
IMPOR IMPOR
IMPORTTTTTANT NO ANT NO
ANT NO ANT NO
ANT NOTE: TE:
TE: TE:
TE:
To obtain maximum battery life, choose the longest
solenoid stroke rate possible.
figure 45
figure 46