Capsule Wiring
8
25
Find out more about capsule
backplates on the next page.
Let's finish the last step of the build by wiring the capsule:
Secure the capsule onto the saddle with two 0-80 x
3/16" screws.
Attach one of the backplate wires to the side of the
capsule with a 0-80 x 1/8" screw and the other one
through one of the saddle screws.
Wires should run through the capsule mount holes
to the front of PCB B.
Solder FD to the front diaphragm, FBK to the front
backplate, RD to the rear diaphragm, RBK to the rear
backplate.
~ Build Notes ~
No need to twist the wires here.
Double-check that each capsule
side has only one diaphragm
wire and one backplate wire.
Make sure that the capsule side
you choose to be the front aligns
with the front of PCB A and the
pattern switch.
Be extra careful not to touch the
capsule membrane with your
bare fingers.
Cover the capsule before
soldering the wires onto the PCB
in order to avoid any solder
splatter.
