
Usage
operating instruction
Hood button
Phone
Key
/
Open
Close
single click
single click
single click
single click
single click
double click
double click
Center console screen
一:Height adjustment
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
The frunk switch speed has 5 gears, the default 4th gear, the lowest 2nd gear, the highest
6th gear. Press and hold the frunk button, when you hear the buzzer sound 2 consecutive
times, it means the speed setting 2nd gear successfully, and so on.
二:Speed Adjustment
Note: Installation instruction may differ slightly from the actual operation, if different,
please operate according to the actual situation or contact us.
**
**
After the installation is completed, the decoder plugged into the power: need to adjust the hood
to the highest, press and hold the hood addition button for 5 seconds. The matching operation is
completed when loosing the button after a long beep
(
Re-powering requires re-operation
)
Note
:
unspecified cables are not installed
Model Y Power Frunk installation instruction
Technology Center - Technical Service Department
Model Y Power Frunk installation instruction
Ensure the inlet connected to the commonly usedoriginal vehicle fuse hole with power,therwise,
the original fuse overcurrent will fuse,measure with a test pencil beforenstallation to ensure
the power inlet.The current direction is shown as the red line inthe diagram
Electricity extractor
Power frunk special fuse
Electricity extractor
(match 20A )
plug in the original vehicle fuse
(
no fuse,no plug)
Power inlet
Principle diagram
Power inlet
Power outlet
Power frunk special fuse
plug in the original vehicle