ST16 USER MANUAL
INTRODUCTION
The ST16 is equipped with a touchscreen display that allows for changing
various settings and viewing real-time telemetry data and streaming video during
flight. The ST16 seamlessly integrates control of the camera so you can easily
take still photos and start/stop video recording using the corresponding
buttons.
OPERATING INSTRUCTIONS:
ST16 AND RECEIVER BINDING
STEP 1): Powe
r on the ST16 and tap “RC” on the main interface
STEP 2): Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.
STEP 3): Tap to create a new model and if required press “OK” to bypass any pop up warn-
ings/alerts.
STEP 4): Tap Flight Settings and if required press “OK” to bypass any pop up warnings/alerts.
STEP 5): Lift the H920 back end upward approximately 45° , then back down to “level” twice till the
main LED indicator blinks yellow.
STEP 6): Tap the Refresh icon. Select the code of the H920 listed in the column under ”Model” and
tap Bind ,then tap “OK” after the connection has been established
STEP 7): When tapping, you will hear two long beeps from the aircraft. That means the ST16 is
bound to the H920 successfully.
STEP 8): Tap [ ] twice to return to the main screen and the model /receiver should automatically
connect to ST16
NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS signal
/lock. The H920 main LED indicator will be solid color of the current mode if the GPS signal/lock is
acquired.
tions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
—Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE WARNING
• This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter. End-users and installers must be provide with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.
IC RADIATION EXPOSURE STATEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired opera-
tion of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled
environment.
Cet équipement respecte les limites d'exposition aux rayonnements IC définies pour un environne-
ment non contrôlé
