Yuchai U35, Руководство оператора

Страница: 84 / 157

4-15
Keeping away from muddy environment
Always handle with caution to avoid getting stuck in the mud. If the machine gets stuck in
mud, follow the steps below to drive the machine out.
A. The track on one side stuck
Attention: When lifting the machine with a boom or bucket arm, make sure that the
bottom of the bucket is in contact with the ground. (Do not push with the bucket
teeth.) The angle between the boom and the bucket arm should be90-110 degrees.
When only one side of the track is stuck in
the mud, lift the track with the bucket, and
then place a wooden board or log under it
to drive the machine out. If necessary,
place wooden boards under the bucket as
well.
B. Both the tracks stuck
If the tracks on both sides are stuck in
mud, slipping, and cannot move. Pad
wooden boards or logs in the above way.
Dig the bucket into the ground ahead,
operate the bucket arm in the same way
as during excavation, and adjust the travel
joystick to the forward position to pull out
the machine.