YSI MultiLab 4010-1W, Руководство по эксплуатации

Страница: 88 / 114

Printer (only MultiLab 4010P-1W) MultiLab 4010-1W
88
ba76141e07 08/2018
12.2 Operation / printing
Data are only output to the printer if the following requirements are met

Data are transmitted manually or automatically (see section 11 T
RANSMIT
-
TING DATA
, page 84)

The printer is switched on (LED illuminated)

There is no USB connection.
12.3 Printer settings
To open the Storage & config menu, press the
<F1__>
[Menü] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with
<M>
.
Default settings are printed in bold .
12.4 Maintenance
12.4.1 Changing the roll of paper (thermal paper)
Menu item Possible set-
ting Explanation
System / Printer /
Font size
12x20
8x16
7x16
Select the font size for the printer
A print sample (font of the printer) to
view the available font sizes can be
output with
<ON/OFF
_
>
.
System / Printer /
Print test page
- The printer prints the meter informa-
tion from the menu
System / Ser-
vice information .
The current printer settings are
used for the print
.
1. Pull the lever (3) until the lid (4) of the paper compartment opens.
2. If necessary, remove any remains of the old roll of paper.
3. Insert the new roll of paper. The start of the paper should poke out of
the paper compartment.
4. Close the lid (4) of the paper compartment so that it clicks into place.
5. If necessary, move the printer paper forward with
<FEED>
.