YSI 5X00
79
YSI 5X00
78
ICONS
(Sensor & Aux)
Meaning
Notes
sensor system is in alarm
set point control mode low range
control relay is energized
(to raise sensor value)
set point control mode high range
control relay is energized
(to lower sensor value)
set point control mode DO low
range 2 control relay is energized (to
raise sensor value)
set point control mode DO high
range 2 control relay is energized (to
lower sensor value)
PID/PWM or PID 4/20mA control
mode is configured for system
table 4.3
Menus
5X00 firmware is structured using menus that enable you to easily configure and
view system status, messages, and logs. The menu structure and screen formats are
very intuitive. Menus are structured in hierarchical fashion. See
Appendix 3 “Menu
Maps”
- beginning on page 225 . Example - figure 4.3 illustrates the menu path to
configure data logging interval.
Configuring the 5X00
Run Screen
Menus
System
Data Logging
Data Logging
Data Logging (Enabled) (1 Hour)
Logging Interval
Time units
Run Screen → Menus → System Menu
� Data Logging�Logging Interval
Menu Hierarchy
after numeric keypad entry and return to “Data Logging” menu
to save configuration and return to Run Screen
7)
8)
Steps to configure data logging interval:
1) select “Menus” at Run Screen
2) select “System” at Main menu
3) select “Data Logging” at System menu
4) select “Data Logging” at Data Logging menu
5) select “Logging Interval” at Data Logging menu
6) input logging interval (1-255) at
(numeric keypad)
Figure 4.3
Configuring the 5X00
