YSI 5200A
99
YSI 5200A
98
9. Press
to save configuration and return to Run Screen.
10. Each slave must be tested one by one. Insert network termination strip
and apply power to the master and the last physical device on the network.
If the master is not the first or last physical device on the network, apply
power and insert network terminal strip on the master and on the first
and last physical devices on the network. Refer to the network wiring
instructions for detailed testing information beginning on page 52.
Testing for proper wiring and configuration can be done one of two ways:
A. After performing step 9, wait at least 30 seconds and then reenter the Com-
munication Master submenu. If the serial number of the slave is displayed
next to the slave address number, the communication network is wired and
configured correctly.
OR
B. After performing step 9, wait at least 30 seconds and then poll the slave
node using AquaManager. If the serial number of the slave is displayed next
to slave address number, the network is wired and configured correctly.
11. Apply power. Insert network termination strip to 5200A/5400 units as
described in the network wiring instructions beginning on page 52.
Repeat network configuration directions starting at step 8 until network
wiring for master and all slaves has been tested.
Configuring the 5200A
Notes:
-
An Event and General alarm (if enabled) will occur if, after ten queries, an
enabled slave does not respond to the Master.
-
Configuring a 5200A as a Master overrides any slave configuration that had
been previously saved.
-
Slave alarms (slave alarm at master and 5200A alarm emails) will not occur
if slave node serial number is not recognized at master node at steps 10. A
or 10. B above.
Termination Relay
Menus → System → Communications → Network →Termination Relay
The termination relay must be enabled on the first and last 5200A on a network. All
other devices should have the termination relay disabled.
Send Test Email Msg
Menus → System → Communications → Send Test Email Msg
Send a test email to verify proper configuration of ethernet menus. Test emails are
only transmitted from configured master 5200As.
Note:
-
Test emails are sent to all configured email address.
-
Exit to Run Screen is required before the test email is sent.
Example of a 5200A test email sent from an ethernet device:
Subject Line: 02/04/10 03:50:05 PM YSI5200A Email Alarm Test Message
From: [email protected]
Sent: Wed, Feb 04, 2010 3:49 pm
To: [email protected]
CC: [email protected]
Configuring the 5200A
