background image

Quick Start Guide

The blade tip recommends leaking a length of about 0.2 mm, 
but new users tend to use too longer blade tip. 
Our idea is to cut only the surface of the sticker, 
but leaving only the minimum scratches under the bottom. 
This way you can easily tear off the adhesive. If you can't cut 
through a small corner or some small details, you can 
increase the length of the blade.
The recommended speed setting is 600 mm / s
The blade force setting 10 - 20.

1. Verify the Package Contents

Power 
cable port

Blade carriage
(Built-in Camera)

Touch screen 
control panel

Set the blade tip to 
only the surface of 
the material without 
cutting the bottom layer

Blade holder 1 pcs

60 degree blade 1 pcs

45 degree blade 2pcs

Pen tool 1 pcs

USB Cable 1 pcs

Cutting Mat 1 pcs

Power adaptor 1 set

2. Note the Names of Parts

U-disk
interface

USB 
cable
port

Blade holder seat:
Tightener for Locking 
Blade Holder

Power button:

Click for power on,
Hold on 3 seconds for power off.

Pinch wheels assembly lever

Up for pressing material, down 
for release material

Pinch wheels assembly 
pressure lever

Up for higher force pressing,
down for normal force.

3. Blade installing instruction

The most commonly used 45-degree case (red cap)
Thin material uses a 60-degree knee (blue cap)

4. Blade tip and blade force / speed value recommended settings

1) Press the silver 
button to eject the blade

3)The tip length can be adjusted by turning the gold knob 
counterclockwise
5)Turn the gold knob clockwise to fix the tip length

4)Adjust the length of 
the tip of the tool holder 
by turning the silver knob

2) The blade can be inserted 
here, be careful that the tip 
of the blade can easily hurt you.

5. Place material

Step 1. Pull down the pinch wheels 
            assembly lever.

Step 2. Move the pinch wheel assembly again the steel axis.

Step 3. Load the material, at least 2 pcs pinch wheels pressing the material.

Step 4. Pull up the pinch wheels assembly lever, make sure material holding well.

Step 5. The blade is the origin point for cutting, move the blade carriage to specify 
            position and then start cutting.

Step 6. If it is print and cut job, need to move the blade tip around 3mm close to the 
            first mark.

First Mark

Отзывы: