9
Installation guide
① Remove plastic caps from front wheel hub.
② Unscrew the adjustment nut from the skewer, remove outer spring and slide the skewer through
the front wheel axle so the quick-release lever is on the same side of the chain.
③ Begin to thread the adjustment nut back onto the skewer, but do not tighten too far. Allow
enough play so you can place the axle into the fork drop out.
④ Slide the wheel into the fork dropout slots. Insert the disc rotor into the center of the disc brake
at the same time you are inserting the wheel axle into the fork drop out.
⑤ Move the quick-release lever into the open position. With one hand on the quick-release lever
and one hand on the adjustment nut, start to hand tighten the adjustment nut until you start to
feel some resistance against the fork.
⑥Try to close the quick-release lever. If it closes easily, open it up and tighten the adjustment nut
further. If it is too difficult to close, open the quick- release lever up and loosen the adjustment
nut a little and try again. Do not attempt to tighten by turning the quick-release lever. The quick-
release lever is for closing, the adjustment nut is for adjusting the tension.
①
②
③
④
⑤
Содержание E-SCOUT
