Setting the seating system (for qualified specialists)
29
4.3
Legrest settings
Lower leg length (fig 4.6).
1. Loosen the bolt.
2. Slide the footplate in the desired
position.
3. Tighten the bolt.
Make sure that there is sufficient free
space under the footplates to operate
the wheelchair over obstacles.
Angle of the footplate (fig 4.7)
1. Loosen the bolt.
2. Set the footplate in the desired
angle.
3. Tighten the bolt.
Legrests width setting (fig 4.4)
See chapter 4.2
Seat depth by legrests (fig 4.8).
1. Loosen the bolt.
2. Slide the legrest holder in the
desired position.
3. Tighten the bolt.
•
Make sure that the castor wheels
do not touch the footplates when
manoeuvring. If this is the case,
the legrests must be brought
forward. There must be at least 1
cm between the castor wheels and
the footplates.
•
Make sure the legrest bracket does
not push into the back of the
knees causing discomfort. If this is
the case, the seat must be
adjusted forward.
Figure 4.6
Figure 4.7
Figure 4.8
