Yosin EVM-2030A, Руководство по программированию

Страница: 12 / 84

11
3. How to Start EVM Programming
Logging in to the System Program
To perform the EVM programming, you need to log in to the System Program and the
Administration Program . To set Special External Phone numbers and the related Remote Switch
Access numbers, you need to log in to some of the Mailbox Programs of the special mailboxes
(9900~9999).
Use either of the following ways to log in to the System Program:
- Plug a standard touch-tone telephone into the “PROG” jack; pick up the handset when the L1
port is not in use.
- Make a phone call to the EVM system; press * * and the system password on hearing the main
greeting.

Hearing the main menu of System Program, you can press 0 for the main menu of
Administration Program.

SYS_6_8 is used to modify the system password (Default= 0#0#).

SYS_6_9 is used to modify the administrator’s password (Default= empty).
Symbols of Programming Paths
This document illustrates programming paths with the following symbols.
Symbols Meanings
ADM Start from the main menu of Administration Program.
SYS Start from the main menu of System Program.
MBxxxx-
VM Start from the main menu of the Mailbox Program of the specified mailbox.
[X] The digit length is 1-digit.
[XX] The digit length is 2-digit.
[XXX] The digit length is 3-digit.
[XXXX] The digit length is 4-digit.
[abcd] The maximum digit length is 4-digit; each digit is a feature option.
[X~] The maximum digit length is 4-digit. To complete inputting a value less than four
digits, you need press # or wait three seconds.
[X~~] The maximum digit length is 16-digit. To complete inputting a value less than
sixteen digits, you need press # or wait three seconds.
(Hex) A Hex value, which consists of two hexadecimal digits: Hex values from 00 to 7F
as shown in the
ASCII character set are used to represent character information.
Hex values from A0 to A9 are used to define the variables of byte.