4
EXM
EXM
Charging Indicator
Whenever AC is connected to the unit, the charging indicator will be turned on. If it is green, the
unit is fully charged. If it is red, the unit is in the process of charging.
Charging the EXM ProSUB
To charge the EXM ProSUB, plug it into an AC power source using the included power cord. The
charging indicator LED is the best indication of the charging status; even if all of the battery
status LEDs are lit, there is still possibly some additional charging time required. The EXM
ProSUB can be safely left connected to AC power for charging indefinitely. It will intelligently
control its own charging regime when plugged in long-term.
The EXM ProSUB will not charge when the temperature is below 0° C or above 45° C.
If the EXM ProSUB is going to be stored unused for a long period of time (greater than 6
months) it is advisable to periodically plug it in to charge up the battery.
If the EXM ProSUB has been stored for a long period of time unused and it has not been maintained,
it is advisable to connect the charger and leave it plugged in for approximately 24 hours.
The EXM ProSUB is delivered with 40-50%
of the charge capacity. Please charge your unit
for 5-hours prior to initial battery operation!
THIS UNIT CA
N
BE OPERA
TED
WHILE CHARGING!
Active or Passive Active
Program Power (watts) 500 watts, program (800 watts, peak)
Measured Max SPL (C-Weighted, Max Hold) 122dB Continuous, 128 dB Peak
Frequency Response (Hz +/- 3dB) 47Hz-100Hz
Crossover Frequency (Hz) 100 Hz Lowpass
Cabinet Configuration Bass Reflex
Driver Configuration 2x 10-inch LF woofer
LF Driver(s) 2x10-inch Neo with 2-inch Voice Coil
LF Impedance (ohms) 4 ohm Load (2x 8 ohm in Parallel)
LF Protection Excursion, Voice Coil Thermal (RMS)
LF Amplifier Type Class D
Cooling Scheme Convection
Power Cable Yes
Power Switch Yes
Power Consumption 150VA
Inputs 2x (L&R) XLR / ¼-inch Combi-jack, Bluetooth
™
, 3.5mm Stereo,
Outputs 2x XLR (L&R)High Pass Out, XLR Full Range Mix Out
Level Controls Sub Level
Limiter Excursion, Thermal (RMS), Clipping
LED Indicators Power, Bluetooth™, Battery Level, Charging Status, Clip
Enclosure Materials 15 mm Birch Plywood
Stacking Feature Interlocking Rubber Feet (top/bottom)
Covering / Finish ABS Laminated
Dimensions (DWH, inches) 20/15.5/27
Dimensions (DWH, cm) 51/39/60
Weight (lbs/kg) 67/30.5
Specifications subject to change without notice
Specifications
Specifications - English
