FORM 160.81-O1 (1020)
ISSUE DATE 10/05/2020
77
JOHNSON CONTROLS
SECTION 2 - OPTIVIEW™ CONTROL CENTER
2
ADVANCED TREND SETUP SCREEN
FIGURE 32 - ADVANCED TREND SETUP SCREEN
00474VIP
Overview
The desired data collection start/stop triggers are setup
on this screen. The trend data collection can be set to
start or stop based upon the status of up to two selected
Triggers. The Triggers can consist of digital events or
analog parameters compared to thresholds. The Trig-
gers can be used individually or in combination. The
digital and analog parameters are selected from the
COMMON SLOTS screen (or Master Slot Numbers
List in this book).
The parameter selected as the Primary Trigger is com-
pared to a value selected as the Primary Test, using the
Primary Operator as a comparator. If it is evaluated as
true, then the data collection is started or stopped (af-
ter any selected Trigger Delay) per the selected Trigger
Action.
A Secondary Trigger can be evaluated with the Prima-
ry Trigger to start/stop data collection. The Primary to
Secondary Operator is used to define the Trigger com-
binations required to be true to start/stop data collec-
tion. The Secondary Trigger is setup and evaluated the
same as the Primary Trigger.
Entry fields are as follows:
If
Primary Trigger
Primary Operator
Primary to Secondary Operator
Secondary Trigger
Primary Test
Secondary Test
Trigger Action
Trigger Delay
Is
Is
then
with a delay of
the data collection
Secondary Operator
After the desired Triggers are set, the START key on
the TREND screen must be manually pressed before
the triggers will be evaluated. While waiting for the
triggers to start or stop data collection, a status message
is displayed in the upper right corner of the TREND
screen describing the pending action.