DESCRIPTION
These outdoor condensing units are completely assembled,
piped and wired at the factory to provide one-piece shipment
and rigging. Each unit is pressurized with a holding charge of
refrigerant-22 for storage and/or shipping.
The compact design, clean styling, and quiet operation make
these condensing units suitable for almost any outdoor
location. On rooftops . . . because they weigh much less than
a single package unit of similar capacity and are much easier
to rig and support. At ground level . . . because their ample
sub-cooling capacity allows them to be located 18 meters (60
feet) below the evaporator coil.
All sheet metal parts are constructed of commercial grade
(G90) galvanized steel. Before painting, each part is thoroughly
cleaned to remove any grease or dirt from its surfaces. The
external parts are then coated a “desert sand” powder paint to
assure a quality finish for many years. This coating system has
passed the 750 hour, salt spray test per ASTM Standard B117.
All models include a 1-year limited warranty on the complete
unit. The compressor carries an additional 4-year warranty.
A matching line of Evaporator Blower units is also offered to
meet your precise capacity and air handling requirements.
FEATURES
•
Condenser coil constructed of rifled copper tubes and
louvered aluminum fins for durability and long lasting
efficient operation.
•
Permanently attached base rails with fork lift slots and lifting
holes. This design allows for 3-way fork lift access and
overhead rigging.
•
Both high and low pressure controls.
•
Solid state motor protection to prevent the compressor from
operating at an unsafe condition.
•
Ball bearing condenser fan motors with 5/8 inch shafts.
•
Color-coded power and control wiring for easier service and
troubleshooting.
•
Anti-short cycle timer to protect the compressor.
•
A lockout circuit to prevent the unit from cycling on safety
control.
•
A 24-volt temperature control circuit.
•
Standard unit low ambient operation to (35
°
F).
•
A filter-drier (shipped in the unit’s compressor
compartment for field installation near the evaporator coil).
•
Service valves with a back-seating access port for pressure
testing the system. Copper stub-outs are factory mounted
on the suction and liquid service valves to simplify the field
piping connections.
•
Separate panel for easy access to the control box without
affecting air flow across the condenser coil.
•
Exterior access to service pressure port connections.
•
Packaging suitable for outdoor storage.
•
An optional Phenolic coating is available where the
condenser coils are fully dipped in a phenolic coating
process to provide longer life in corrosive conditions.
550.23-TG3Y (398)
SPLIT-SYSTEM
AIR-COOLED
CONDENSING UNITS
H3CE180 & 240
15 AND 20 NOMINAL TONS
®
O
O
O
Содержание H3CE180
Страница 11: ...550 23 TG3Y Unitary Products Group 11...
