<2. Receiving and Storage>
7
IM 01E25A01-01EN
2. Receiving and Storage
When the instrument is delivered, check visually that no
damage has occurred during transportation. Also check
that all flowmeters mounting hardware shown below is
included.
Integral Flowmeter
Model
Part name
Qty.
AXW###G
Blanking Plug (*1)
0 to 2 pcs.
Remote Transmitter
Model
Part name
Qty.
AXW4A
Mounting Bracket
1 set
Blanking Plug (*1)
0 to 2 pcs.
AXG1A
Mounting Bracket
1 set
AXFA11G
Mounting Bracket
1 set
*1:
When the following code is specified for “Power Supply”
and “Converter, Communication, I/O”, the following
quantity of blind plug is attached.
Power Supply code Communication and I/O code
Qty
-1
-D, -E, -M, -F
1 pc.
Other than those above
0 pc.
-2
-D or -E
2 pcs.
-P
0 pc.
Other than those above
1 pc.
2.1 Model and Specifications
Check
As shown in Figure 2.1 to Figure 2.5, the model, suffix
code, serial number, meter factor, fluid specification, and
device information are found on the name plate located on
the outside of the housing. And, this instrument can check
their information from parameters. Read the user’s manual
of applicable communication type as listed in Table 1.1 for
checking device information from parameters.
When checking the matching of model and specification you
ordered, see the applicable general specifications as listed in
Table 1.1.
Be sure you have the model code and serial number
available when contacting YOKOGAWA.
Note: Description on the nameplate
- Made in _______: Country of origin
- COMB No.: Serial number of the combined remote
sensor or remote transmitter
F0201.ai
Figure 2.1 Name Plate (AXW Integral Flowmeter)
F0202.ai
Style: S1
Style: S2
Figure 2.2 Name Plate (AXW Remote Sensor)
Receiving and Storage
2
