YOKOGAWA ZR22S, Руководство пользователя

Страница: 107 / 206

<7. Startup>
7-7
(3) At the time of entering the numeric-data entry display, the output current will change to 4 mA
(default value). If the desired current is entered, the corresponding output will be provided.
mA - output 1

mA - output 2
Enter
mA - output loop check
F07-15E.ai
Figure 7.15 “mA - output loop check” Panel Display
7.11 Checking Contact I/O
Conduct the contact input and output checking as well as operational checking of the solenoid
valves for automatic calibration.
7.11.1 Checking Contact Outputs
To check the contact output, follow these steps:
(1) Press the [Setup] key in the Basic panel display to display the Execution/Setup display.
Select “Maintenance” in that display.
(2) Select “Contact check” then “Output contacts” in the Maintenance panel display to display
the Output contacts display (see Figure 7.17).
(3) In this display, select the desired “output contact” for checking. The display, which enables the
closing and opening of contacts, then appears. Use the display to conduct continuity checking.
Output contacts

Calibration contacts

Input contacts
Enter
Contact check
F07-16E.ai
Output contact 1 : Open

Output contact 2 : Open

Output contact 3 : Open

Output contact 4 : Open
Enter
Output contacts
F07-17E.ai
Figure 7.16 “Contact Check” Display Figure 7.17 “Output contacts” Check Panel Display
CAUTION
• If you conduct an open-close check for “Output contact 4”, Error 1 or Error 2 will occur.
This is because the built-in heater power of the detector, which is connected to “Output contact
4”, is turned off during the above check. So, if the above error occurs, reset the equipment
or turn the power off and then back on to restart (refer to Section 10.6, “Reset”, later in this
manual).
IM 11M13A01-02E