YOKOGAWA ZR202S, Руководство пользователя, Страница: 99 / 163

<8. Detailed Data Setting>
8-18
IM 11M13A01-04E
Procedure
Use the parameter code table below to set fuel values.
Table 8.17 Setting Fuel Values
Set item Parameter code Set value Engineering units
Amount of water vapor in
exhaust gas
F20 0 to 5 m
3
/kg (m
3
)
Theoretical amount of air F21 1 to 20 m
3
/kg (m
3
)
X value F22 0 to 19.99
Absolute humidity of the
atmosphere
F23 O to 1 kg/kg
Default Values
When the analyzer is delivered, or if data are initialized, parameter settings are by default, as shown in
Table 8.18.
Table 8.18 Default Settings of Fuel Values
Item Default setting
Amount of water vapor in exhaust gas 1.00 m
3
/kg (m
3
)
Theoretical amount of air 1.00 m
3
/kg (m
3
)
X value 1.00
Absolute humidity of the atmosphere 0.1000 kg/kg
8.7.4 Setting Purging
Purging is to remove condensed water in the calibration gas pipe by supplying a span calibration
gas for a given length of time before warm-up of the detector. This prevents cell breakage during
calibration due to condensed water in the pipe.
Open the solenoid valve for the automatic calibration span gas during purging and after the purge time
has elapsed, close the valve to start warm-up.
Purging is enabled when the cell temperature is 100°C or below upon power up and the purge time is
set in the range of 1 to 60 minutes.
F8-5E.ai
Displayed alternately
Figure 8.5 Display during Purging
Procedure
Use the parameter-code table below to set the purging time.
The allowable input ranges from 0 to 60 minutes.
Table 8.19 Purging Time
Set item Parameter code Set range Units
Purging time F15 0 to 60 minutes
Default Value
When the analyzer is delivered, or if data are initialized, purging time is set to 0 minutes.