YOKOGAWA YS80 Series, Руководство пользователя

Страница: 30 / 42

7-2
IM 01B04N01-02E
7.1 Action in Fault Condition
The output condition and error codes (BRAIN communication parameters) in fault condition
are shown in the table below.
• STATUS is displayed in A54 of A: DISPLAY (display), and SELF CHK is displayed in
60 of each item.
• STATUS error code is to be the addition display (hexadecimal number) when two
errors or more occur.
BRAIN Communication Parameter
aDisplay
Output Condition Description of Error Remedy
STATUS SELF CHK Error Information
(*1)
Same state as power off
Output: 0% or less
Communication
：
Stopped
Hardware failure Contact YOKOGAWA's sales
office or sales representative. Power failure, Fuse
broken
0001 ERROR EEPROM ERROR Output: 0% or less
Communication ： Undefined
EEPROM error
0002 ERROR EEPROM SUM
ERROR
Output: 0% or less
Communication ： Undefined
Parameter error
1000 ERROR AD ERROR Output: 0% or less
Communication ： Normal action
A/D conversion error
0008 ERROR INPUT OVER
RANGE
Output: Normal action
Communication ： Normal action
Excessive input, out of
-25 to 125%
Set the input within the range.
(*2)
0004 GOOD LOW_CUT Output: Normal action
Communication ： Normal action
Input below the square
root characteristic with
low-cut
Apply the input greater than
the low-cut point.
0040 GOOD None Output: Normal action
Communication ： Normal action
Check power failure
during operation
Write "0000" at the
STATUS display of BRAIN
communication parameter
0000 GOOD None Output: Normal action
Communication
：
Normal action
- -
*1: Displayed when calling

60: SELF CHK .
*2: If errors continue even when the input is within the range, the input circuit is broken.
Contact YOKOGAWA's sales office or sales representative.