IM 701240-02E
Recording X-Y (Amplitude-Amplitude) Waveforms
Starting/Stopping the X-Y Waveform Recording
Section 9.6, "Recording X-Y Waveforms" in the user's manual
Start recording
Press
START/STOP
.
The RECORD indicator illuminates.
The waveform signal is acquired into the SL1400, and the display on the screen starts.
Stop recording
Press
START/STOP
while the recording is in progress.
The RECORD indicator turns OFF.
The acquisition of the waveform signal and the updating of the display stop, and recording on the
built-in printer starts.
Scale value of the Y-axis
(upper limit) 2.500 V
Scale value of the Y-axis
(lower limit) –2.500 V
Scale value of the X-axis
(left-most value) –2.500 V
Scale value of the X-axis
(right-most value) 2.500 V
Voltage range (measurement range) of CH2 5.00 V
Sample rate 5 kS/s
The X-Y waveform (Lissajous waveform) shown above is a graph in which
the CH1 and CH2 signals are assigned to X- and Y-axes, respectively.
The T-Y (time-amplitude) waveform display of
CH1 and CH2 signals
CH1 and CH2 signals
• Amplitude
Both approximately 5-V sine waves
(repetitive signal)
• Frequency
CH1: 1 Hz
CH2: 4 Hz
• Phase difference between CH1 and CH2
signals
No phase difference
(Because the CH2 range was set last on page 33 in this operation
guide, the CH2 range is displayed here.)
RECORD
START/
STOP
RECORD
START/
STOP