IM 701240-02E
Setting the Record Conditions
Initializing Settings
Section 4.4, "Initializing Settings" in the user's manual
The settings entered using the front panel keys are reset to factory default.
This operation is not necessary if you are using the SL1400 for the first time after purchase. However, please execute the
operation for your learning. This initialization operation is useful when you wish to redo the settings from scratch according to
the input signal.
4
Press the
Initialize
soft key.
Initialization is executed.
Press here to set the SL1400 back to
the condition that existed immediately
before the initialization.
1
Press
MENU
.
2
Press the
Next 1/2
soft key.
3
Press the
INITIALIZE/CAL
soft
key.
MENU
Note
• When you initialize, the display of all channels in which modules are installed is turned ON in the stopped condition. In X-Y
Recorder mode, the X-Y display showing the CH1 range appears.
• The items that cannot be initialized using the Initialize soft key are as follows:
Settings such as the date/time, recorder mode, language, communication parameters, and SCSI ID.
• To initialize all settings except the date/time, carry out the procedure below. You cannot restore the settings. The stored setup data
is also initialized (see section 13.1 in the user’s manual).
[Turn ON the power switch while holding down the RESET key]
Recording X-Y (Amplitude-Amplitude) Waveforms
