IM 701240-02E
Recording T-Y (Time-Amplitude) Waveforms
Changing the Chart Speed to 20 mm/sec
Section 9.2, "Setting the Record Conditions of T-Y Waveform Recording" in the user's manual
Here, we set the chart speed for recording to the built-in printer, so that a sine wave of approximately 1 Hz can be observed.
1
Press
CHART SPEED
.
2
Turn the
jog shuttle
clockwise to
select 20mm/sec.
CHART
SPEED
Starting/Stopping the T-Y Waveform Recording
Section 9.4, "Recording T-Y Waveforms" in the user's manual
On the screen, the waveform is displayed flowing
from right to left (roll mode display) with the time per
division set to 500 ms.
On the built-in printer, the paper is fed at a speed of
20 mm/s, and the waveform is recorded.
A ↓ mark is displayed at the right edge of the waveform display area at the top. This mark points to the
right-most position of the waveform display area and indicates the position where the waveform acquisition
was stopped. In this example, the waveform acquisition was stopped at 16:37:34 on September 15, 2006.
Start the recording
Press
START/STOP
.
The RECORD indicator illuminates.
The waveform signal is acquired into the SL1400, and the display on the screen and the recording
to the built-in printer start.
Stop the recording
Press
START/STOP
while the recording is in progress.
The RECORD indicator turns OFF.
The acquisition of the waveform signal is stopped, and the updating of the display and recording on
the built-in printer stop.
Scale value (upper limit) 2.500 V
Scale value (lower limit) –2.500 V
Voltage range
(measurement range) 5.00 V
T/div (time per division) 500 ms/div
Chart speed 20 mm/sec
Ground level mark
Direction in which
the current flows
RECORD
START/
STOP
RECORD
START/
STOP
