YOKOGAWA ScopeCorder DL950, Руководство пользователя

Страница: 19 / 316

2-3
IM DL950-02EN
Channel Setup Menu
1.
On the waveform screen’s MENU , tap VERTICAL > CH , or press CH . A channel setup menu
appears.
You can also tap the channel information display area at the top of the screen to display the
channel setup menu.
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
For a 4-CH module (720254 (4CH 1M16) or 720256 (4CH 10M16)), select a sub channel (a
channel number followed by an underscore and a number as in CH3_1 if the display label is
set to default).
Scope Mode
4-CH module display
Turns the waveform
input on or off
Set the display label.
See “Setting the Input
Coupling.”
See “Setting the Probe
Attenuation or the
Current-to-Voltage
Conversion Ratio.”
See “Setting the
Bandwidth Limit and
Digital Filter.”
See “Configuring
the Display.”
See “Setting the Display Range
in Scope Mode.”
See “Setting the Adjustment (DC offset
cancellation, gain adjustment).”
Turns the inverted display on or off
See “Setting the Sample Rate.”
Channel setup menu (2/2)
Set the bandwidth limits.
See “Setting the Linear Scaling.”
Channel whose waveform input is on (filled)
Channel Setup Menu on models other
than /G03 and /G05 models (1/2)
(Including the 720254 and 720256 on
/G03 and /G05 models)
Channel Setup Menu on /G03 and
/G05 models (1/2)
(excluding 720254 and 720256)
Channel being configured
Channel whose waveform input is off
2.1 Configuring Voltage Measurements (on modules other than 16-CH temperature/voltage input modules)