YOKOGAWA HANDY CAL CA51, Руководство пользователя

Страница: 79 / 108

8-2
IM CA71-E
8.2 Setting the Mode
8.2 Setting the Mode
Step 1: Press the key while simultaneously holding down the
key. The LCD shows in its upper section and either ,
or in its lower section.
Step 2: Using the pair of and keys, select , or .
Step 3: Press the key to confirm your mode selection. If you set
the mode to or , the LCD shows . When the
is indicated, each press of the key outputs one
data item.
Step 4: If you set any value using the pair of and keys with
shown, the calibrator outputs data using the value thus
set as the time interval (sec). The value should be set within
the range from 0 to 3600.
TIP
• To close the communication setting screen, press the key once again while
simultaneously holding down the key.
• Even if you turn off the calibrator, the communication mode and interval you have
set are saved internally until you replace the batteries or reconfigure the communi-
cation function. Thus, communication will take place with the previous settings.
8.3 Types of Mode
: Normal mode – Permits normal transmission and reception.
: Talk-only mode – Outputs the source setpoint and measured
value at preset intervals (0* to 3600 sec).
: Printer mode – Outputs the source setpoint and measured
value to a printer at preset intervals (0* to
3600 sec).
*: For a 0-second interval, each press of the key outputs one data
item. For other intervals, pressing the key initiates or terminates
communication.