YOKOGAWA FA-M3V e-RT3 Plus, Руководство по оборудованию

Страница: 88 / 274

A2-54
IM 34M06C11-01E
(17) F3YC08-0C/F3YC08-0N Relay Output Module
Item
Specifications
F3YC08-0C F3YC08-0N
Output type Relay contact
Number of points 8
Common line type All points independent 8 points/common
Isolation method Mechanical insulation
Withstanding voltage
1500V AC for one minute between the group of terminals for external connection
and the internal circuit
Rated load
voltage range
(
maximum load
voltage
)
DC 5-24V ( 125V )
AC 100-240V ( 264V )
Maximum load current 2A/point
(
resistive load
)
2A/point, 8A/common line
( resistive load )
Maximum switching
capacity
530VA/point, or 60W/point (for resistive load)
Minimum load
voltage/current
5V DC, 10mA
Response
time
OFF
→
ON 10ms max.
ON
→
OFF 10ms max.
ON voltage ───
Off-time leak current
───
Service
life
Mechanical 20 million operations or more
Electrical 100,000 operations or more
(
rated load
)
Surge protector
*1
None
Fuse None
Dissipating current 205mA
(
5V DC
)
Output display *2 LED
(
Lit when output is on
)
Output status when the
program stops
HOLD/RESET
*3
When a sequence CPU module is used:
Default: RESET; can be set globally on a module-by-module basis.
When a BASIC CPU module is used:
No setting function; the status is always HOLD.
External power supply Not required
External connection 18-point terminal block with M3.5 screws 10-point terminal block with M3.5 screws
Weight 180g 160g
*1: If an inductive load, such as a relay, is to be connected, a surge protector is required on the load side. Connect a
surge protector or a diode across the load nearby so that the module output terminal voltage will not exceed the
specified operating load voltage range. For details, see Subsection A3.6.5, “Connecting Output Devices.”
*2: The contact operation of the output block of the circuit and the LED display operate independently and thus may be
inconsistent in the event of an error.
*3: For information on the module’s behavior during a CPU failure, see subsection A4.3.3, “Indicating Problem Severity
and Status of Output Module.”
WARNING
Don’t connect DC load and AC load to single module together.
Don’t connect loads from different AC sources to single module together.
In case of using these loads at once, connect to different relay output modules
separately.