YOKOGAWA DLM5034, Руководство пользователя

Страница: 9 / 156

vii
IM DLM5058-03EN
Optional Accessories (Sold separately)
The optional accessories below are available for purchase separately. For information about
ordering accessories, contact your nearest YOKOGAWA dealer.
• Use the following accessories within the ranges indicated in the specifications of each accessory.
When using several accessories together, use them within the specification range of the
accessory with the lowest rating.
• If you use accessories other than those below, YOKOGAWA assumes no responsibility or liability
for the specifications of this instrument or any damage caused by the use of this instrument.
• Accessories (sold separately) are not covered by warranty.
Group 1
Compliance with EN standards is achieved by using the following in combination with the
instrument.
Item
Model or
Part No.
Min.
Q’ty General Specifications
Manual No.
500 MHz passive probe 1 701937 1
DC to 500 MHz bandwidth, maximum
input voltage ±600 V (DC+AC peak)
IM 701937-01EN
Miniature passive probe 1 701949 1
DC to 500 MHz bandwidth,
maximum input voltage 400 Vrms
IM 701949-01EN
Passive probe 1
(wide temperature range)
702907 1
DC to 200 MHz bandwidth, maximum
input voltage ±1000 V (DC+AC peak)
operating temperature range: ‒40°C to
+85°C (excluding the phase adjustment
side)
IM 702907-01EN
PBL100 logic probe 1 701988 1
Maximum toggle frequency: 100 MHz,
input voltage: ±40 V
IM 701988-01E
PBL250 logic probe
1
701989 1
Maximum toggle frequency: 250 MHz,
threshold level: ±6 V, input voltage:
threshold level setting ± 6 V
IM 701989-01E
PBL500 5 GHz resistance
probe
701974 1
DC to 5 GHz bandwidth,
maximum input voltage: 20 Vrms
IM 701974-01E
50 ΩDC block 701975 1 Frequency range: 30 MHz to 6 GHz IM 701975-01E
Mini clip adapter 700971 1 set — —
BNC adapter 700972 1 — —
50 Ω terminator
2
700976 1 DC to 500 MHz bandwidth IM 700976-01JE
BNC cable 366924 1 1 m —
BNC cable 366925 1 2 m —
PCB adapter 366945 1 set — —
Solder-in adapter 366946 1 set — —
Probe stand 701919 1 — IM 701919-01E
GO/NO-GO cable 366973 1 — —
Connection cable
701982-01 1 For DLMsync, 1.0 m —
701982-02 1 For DLMsync, 2.8 m —
Soft carrying case 701968 1 Shoulder type, three pockets —
Rack mount kit
701969-E 1 EIA standard IM 701969-02EN
701969-J 1 JIS standard IM 701969-01EN
Printer roll paper B9988AE 10 Heat-sensitive paper, 111 mm × 10 m —
1 The accessory by itself also complies with EN standards.
2 Used to terminate the external trigger at 50 Ω.
Checking the Contents of the Package