5-15
5
IM 701830-01E
Vertical and Horizontal Axes
5.12 Setting the ON/OFF of Channels and the V/div
with the All Channel Setting Menu
Function
The ON/OFF of each channel and the V/div setting are explained in pages 5-1 and 5-4
respectively. This section explains the procedure in displaying information on all the channels
simultaneously and setting the ON/OFF and V/div settings for the individual channels.
Note that, channels that have temperature modules, logic input modules, or strain modules
installed can not set the V/div settings.
Display of the all channel setting menu
The all channel setting menu is displayed after carrying out the following operating procedure.
•
When the
ESC
key is pressed repeatedly
•
Just after initialization has been completed
•
Just after auto set-up has been completed
•
When data is loaded from the floppy disk/internal hard disk/external SCSI device
Operating Procedure
Selecting the channels
1.
In any of the above cases, the all channel setting menu appears as shown below.
2.
Turn the jog shuttle to select the desired channels.
Proceed to step 3 or 4 depending on which settings you want to make.
Turning the channel ON/OFF
3.
Press the
SELECT
key to select “
ON
” or “
OFF
”.
Setting the V/div
4.
Turn the
V/DIV
knob to set the desired V/div value.
5.
Repeat steps 2 to 4 until you have made all the settings you want.
Note
Channels which do not have input modules installed are not displayed on the all channel setting menu.
