2
2-3
IM 701830-01E
Name and Use of Each Part
2.2
Operation Keys/Jog Shuttle/Knobs
VERTICAL Group
Keys
CH1 to CH16 keys (Pages 5-1 to 5-17)
Displays the menu for setting the ON/OFF state, offset voltage, coupling, probe attenuation,
preset, bandwidth limit, invert, linear scaling value for each channel. Also, it allows you to
select the channel to operate with the V/div knob (for voltage modules only). When the display
is turned ON, the LED above the key lights up.
Press the
SHIFT + CH1 (CH2)
keys to display the setup menu for “LOGIC1” (“LOGIC2”).
V/DIV knob (Page 5-4)
Sets the voltage axis sensitivity. Before turning this knob, be sure to select the channel you
want to adjust by pressing the corresponding channel key (CH1 to CH16).
If you change the scale while acquisition is suspended, the new value becomes effective when
acquisition resumes.
This knob is applicable only to channels which have the voltage module installed.
HORIZONTAL Group
TIME/DIV knob (Page 5-2)
Use this knob to set the time scale. If you change the scale while acquisition is suspended, the
new value becomes effective when acquisition resumes.
TRIGGER Group
SIMPLE key (Pages 6-1 to 6-9)
Displays the menu for the simple trigger, which triggers on a single trigger source.
Simple
trigger mode is selected when the indicator located above this key is lit.
ENHANCED key (Pages 6-1 to 6-8 and 6-10 to 6-20)
The enhanced trigger menu for setting complex triggers such as A
→
B(n) trigger, is displayed.
Enhanced trigger mode is selected when the indicator located above this key is lit.
POSITION/DELAY key (pages 6-6 to 6-8)
Use this key to set the trigger position or trigger delay.
TRG’D indicator
Lights up when a trigger is activated.
T I M E / D I V
HORIZONTAL
SIMPLE
TRIG D
ENHANCED
POSITION
/ DELAY
TRIGGER
V / D I V
CH
1
CH
2
CH
3
CH
4
CH
5
CH
9
CH
10
CH
11
CH
12
CH
6
CH
7
CH
8
7 LOG/C1
8
9
EXP
4
5
6
m
1
CH
13
CH
14
CH
15
CH
16
0
ENTER
2
3
µ
LOG/C2
VERTICAL
