YOKOGAWA DL716, Руководство пользователя

Страница: 237 / 255

15-15
15
IM 701830-01E
Specifications
15.24 Strain Module (701880)
Item Specifications
Number of channels 1
Maximum sample rate 100 kS/s
Input method DC bridge input method (Auto balancing method), Balanced differential input method, DC
amplifier (floating)
Auto balancing method Electronic auto balance
Auto balance range ± 10000 × 10
-6
strain
Bridge voltage Selectable 2V/5V
Bridge resistance Need to externally connect a strain gauge bridge or strain gauge transducer with a cable.
Recommended bridge head: 700932 (bridge resistance of 120
Ω ) or 700933 (bridge resistance of 350
Ω )
Applicable bridge resistance 120 to 1000 Ω (at bridge voltage 2 V), 350 to 1000 Ω (at bridge voltage 5 V)
Gauge factor 1.90 to 2.20 (in 0.01 steps)
Frequency characteristics*
1
DC to 20 kHz
(–3 dB point when sine wave
of amplitude
± 3 div is input)
Measurement range/accuracy
*1*2
Range Measurement range (FS) Accuracy
1000 × 10
– 6
strain ± 1000 × 10
– 6
strain ± 1 % of FS ± 1000 × 10
– 6
strain
2000 × 10
– 6
strain ± 2000 × 10
– 6
strain ± 1 % of FS ± 1000 × 10
– 6
strain
5000 × 10
– 6
strain ± 5000 × 10
– 6
strain ± 1 % of FS ± 1000 × 10
– 6
strain
10000 × 10
– 6
strain ± 10000 × 10
– 6
strain ± 1 % of FS ± 1000 × 10
– 6
strain
20000 × 10
–6
strain ± 20000 × 10
–6
strain ± 1 % of FS ± 1000 × 10
– 6
strain
Maximum input voltage (across terminals)
(At 1 kHz or less) 5 V (DC+ACpeak)
Maximum allowable common (across each terminal and earth)
mode voltage 42 V (DC+ACpeak) (CAT I and II, 30 Vrms)
(At 1 kHz or less)
Input connector NDIS (A connector recommended by JSNDI (The Japanese Society for Non-destructive
Inspection.))
Input resistance 10 M Ω or more
Common mode rejection ratio 80 dB(50/60Hz) or more, signal source resistance 1 k Ω
A/D conversion resolution 14 bit
Temperature coefficient
Zero point
± 5 × 10
–6
strain/ ° C (after input conversion and auto calibration)
Gain ± (0.05 % of FS)/ ° C (after auto calibration)
Bandwidth limit Select OFF/10 Hz/100 Hz/1 kHz, -12 dB/Oct
*1 Measured value under standard operating conditions (refer to page 15-6)
*2 Gauge factor 2, accuracy of the strain module only
A
B
C
D
E
F
G
A :
B : Input–(measurement signal–)
C : Bridge–
D : Input+(measurement )
E : Floating common
F : Sense+
G : Sense–
Pin assignments
Top view
The connector shell is connected
to the functional earth.