SM 04L01A01-01E
3-4
DX200
WARNING
• For safety reasons, make sure to turn OFF the power switch and disconnect the
recorder from the main power supply before replacing the fuse.
• To prevent the possibility of fire, use only the specified fuse purchased from
YOKOGAWA.
• Never short circuit the fuse holder to bypass the use of a fuse.
Follow the procedures below to replace the fuse.
1.
Turn OFF the power switch.
2.
Disconnect the recorder from the main power supply.
3.
While pushing in the fuse carrier located to the right of the power switch, turn it
counter-clockwise approximately 45 degrees. The carrier and the fuse will slide out.
Figure 3.2 Fuse illustration (DX200)
4.
Replace with a new fuse, insert the carrier to the fuse holder, and turn it clockwise
while pushing in the carrier to fix it in place.
3.5 Replacing the Battery
This battery will last for ten years under normal operating conditions. For replacement,
please contact your nearest sales and service office; addresses may be found on the
back cover of this manual.
To avoid injury, do not replace the lithium battery yourself or disassemble this recorder to
attempt the replacement.
3.4 Replacing the Fuse/3.5 Replacing the Battery