15-4
IM AQ1300-01EN
15.4 Configuring Network Settings
Procedure
Network Setup Screen
1.
Press the
System
soft key and then the
System
soft key.
2.
Using the
rotary knob
and
ENTER
, select
Network Setup
to display the following screen.
Enables or disables the network setup
Set the host name, user name, and password.
To set the host name, user name, and password,
follow the procedure in section 3.2.
Set the timeout value.
TCP/IP settings
Note
You must restart the AQ1300/AQ1301 after you have changed the network settings. Before you restart the
AQ1300/AQ1301, the settings from before you changed the settings are used.
Explanation
For details about the network that you intend to connect the AQ1300/AQ1301 to, contact your network
administrator.
Enabling or Disabling the Network Setup
After you have set the user name, password, timeout value, and TCP/IP parameters, select Valid to
use the network connection.
Valid
The AQ1300/AQ1301 can communicate over the network.
Invalid
The AQ1300/AQ1301 cannot communicate over the network.
If Valid is selected and the AQ1300/AQ1301 is not connected to a network, it will require more time to
start.
Host Name, User Name, and Password
Specify the host name for when you are performing remote control in Auto(Remote) mode using the
test interface and for when you are searching for other devices.
Set the user name and password to use for user authentication when the AQ1300/AQ1301 is accessed
by a PC.
The password is also used for authentication in Auto(Remote) mode when you are performing remote
control using the test interface.
Host Name
You can use up to 11 characters.
User Name
You can use up to 15 characters. The default setting is “anonymous.”
Password
You can use up to 15 characters.
