8-22
IM AQ1300-01EN
8.9 Configuring
Packet Jitter Test Settings
Procedure
Packet Jitter Test Setup Screen
Follow the procedure in section 8.1 to display the RFC2544 Setup screen.
Press the
Detail Setup
soft key and then the
Packet Jitter Setup
soft key to display the following
screen.
Set the test duration (1 to 999).
Set the number of trials (1 to 60).
Select this check box to measure at the
throughput result rate.
Set the measurement rate (0.01 to 100.00).
Set the test window size (100ms, 500ms,
1s, 10s, Test duration).
Set the measurement resolution (Auto,
0.05ms, 0.1ms, 0.5ms, 1.0ms, 2.5ms, 5.0ms).
Set the delay variation threshold
(50Percentile, 75Percentile, 90Percentile).
Select this check box to perform
pass/fail judgment.
Set the upper limit on the delay variation
(0.05 to 300.00).
Explanation
Test Duration
Set the test duration. The value that you specify here is the time that a single test frame is
transmitted for.
Range: 1 to 999 seconds
Number of Trial
Set the number of trials that you want to perform.
Range: 1 to 60
Result of Throughput Test
Set whether to use the result of the throughput test as the packet jitter test’s measurement rate.
• Selected: The result of the throughput test is used.
• Cleared: The result of the throughput test is not used.
Test Rate
Set the measurement rate of the packet jitter test. You can specify this value when you are not
using the result of the throughput test as the measurement rate.
Range: 0.01 to 100.00%
