8-17
IM AQ1300-01EN
Configuring RFC2544 Measurement Settings (AQ1300 Option)
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
8.6 Configuring
Latency Test Settings
Procedure
Latency Test Setup Screen
Follow the procedure in section 8.1 to display the RFC2544 Setup screen.
Press the
Detail Setup
soft key and then the
Latency Setup
soft key to display the following screen.
Set the test duration (1 to 999).
Set the number of trials (1 to 60).
Select this check box to use the
throughput test result.
Set the measurement rate (0.01 to 100.00).
Set the upper limit on the delay
(0.1 to 999999.9).
Select this check box to perform
pass/fail judgment.
Explanation
Test Duration
Set the test duration. The value that you specify here is the time that a single test frame is
transmitted for.
Range: 1 to 999 seconds
Number of Trial
Set the number of trials that you want to perform.
Range: 1 to 60
Result of Throughput Test
Set whether to use the result of the throughput test as the latency test’s measurement rate.
• Selected: The result of the throughput test is used.
• Cleared: The result of the throughput test is not used.
Test Rate
Set the measurement rate of the latency test. You can specify this value when you are not using the
result of the throughput test as the measurement rate.
Range: 0.01 to 100.00%
