8-15
IM AQ1300-01EN
Configuring RFC2544 Measurement Settings (AQ1300 Option)
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
8.5 Configuring
Throughput Test Settings
Procedure
Throughput Test Setup Screen
Follow the procedure in section 8.1 to display the RFC2544 Setup screen.
Press the
Detail Setup
soft key and then the
Throughput Setup
soft key to display the following
screen.
Set the test duration (1 to 999).
Set the number of trials (1 to 60).
Set the initial rate (0.01 to 100.00).
Set the minimum rate (0.00 to 100.00).
Set the maximum rate (0.01 to 100.00).
Set the resolution (0.01 to 100.00).
Set the acceptable loss
(0.00001 to 100.00000).
Select this check box to perform
pass/fail judgment.
Set the judgment threshold
(0.01 to 100.00).
Explanation
Test Duration
Set the test duration. The value that you specify here is the time that a single test frame is
transmitted for.
Range: 1 to 999 seconds
Number of Trial
Set the number of trials that you want to perform.
Range: 1 to 60
Initial Rate
Set the initial traffic rate that the throughput test will use.
Range: 0.01 to 100.00%
Min Rate
Set the minimum rate that the result of the throughput test will be converged toward. Enter a value
that is less than or equal to the initial rate.
Range: 0.00 to 100.00%
Max Rate
Set the maximum rate that the result of the throughput test will be converged toward. Enter a value
that is greater than or equal to the initial rate.
Range: 0.01 to 100.00%
