5-3
IM AQ1300-01EN
Automatic (Remote Control) T
est Settings (Auto(Remote))
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
5.2 Setting Up a Test
Procedure
Test Setup Screen
Follow the procedure in section 5.1 and then select a setup file to display the following screen.
Select this check box to treat oversize
frames like normal frames.
Select this check box to add UDP to Tx
frames.
This setting can be selected when Test
Layer is set to L3-IPv4 Test or L3-IPv6
Test.
Configure the link settings.
►
section 5.3
Select a setup file
►
section 5.1
Set the test interface
(XFP(10GbE), SFP(GbE), RJ-45).
Set the test layer
(L2 Test, L3-IPv4 Test, L3-IPv6 Test).
Explanation
Test Interface
Specify which test interface to use.
• XFP (10GbE): Select this option to use the 10GBASE-R measurement port.
• SFP (GbE):
Select this option to use the 1000BASE-X measurement port.
• SFP (FE):
Select this option to use the 100BASE-FX measurement port.
This interface is supported by firmware version R1.05.01.001 or later.
• RJ-45:
Select this option to use the 10BASE-T/100BASE-TX/1000BASE-T measurement
port.
Test Layer
Set the layer to test.
• L2 Test:
Select this option to test layer 2.
• L3-IPv4 Test: Select this option to test layer 3 according to the IPv4 protocol.
• L3-IPv6 Test: Select this option to test layer 3 according to the IPv6 protocol.
Add UDP to Tx Frame
Select whether or not to add UDP to Tx frames. You can configure this setting when the test layer is
L3-IPv4 or L3-IPv6.
Use Jumbo Frame
Select whether or not to treat oversize frames like normal frames.
• Selected: Frames with lengths of 64 to 9999 bytes are treated as normal frames.
• Cleared: Frames whose size is above 1518 + the value set for “VLAN stacks” in the source
settings × 4 are considered oversized.
