2-1
IM AQ1200-01EN
Common Operations
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
App
Index
20
2.1 Top Screen
When you turn the AQ1200x/AQ1205x on and it starts, the top screen appears. First select a feature
from this top screen, and then configure the feature or carry out the measurement that corresponds to
the feature you have selected.
1.
Turn on the Instrument.
2.
Use the
rotary knob
to select the feature.
An image that shows the selected feature is displayed, and the feature name is displayed in the upper left
of the screen.
3.
Press the center of the
rotary knob
or
ENTER
to confirm your selection.
The setup or measurement operation menu for the selected feature is displayed.
In this manual, steps 2 and 3 above are described as shown below.
Example: To select the OTDR feature and confirm it:
“Using
the
rotary knob
and
ENTER
, select
OTDR
.”
Displays a term that
represents the selected
feature
• OTDR
• LS_OPM
• Auto Loss Test
• Multi-Core Loss Test
• IP Test
• Fiber Inspection Probe
• Fault Locator
• Visible Light Source
• PON_OPM
• Multi-Core Fiber Meas
• OTDR Event Mapper
Top Menu
Displays an image that shows
the selected feature
Rotary knob
ENTER key
The center
of the rotary
knob
Displays an explanation of the selected feature
Procedural Explanations of Features
For explanations of the procedures to perform after you have selected and confirmed a feature, see
the chapters or sections that are listed in the following table.
Function
Reference
OTDR (optical pulse measurement)
Chapters 3 to 7
LS_OPM (power meter and light source)
Chapters 8 and 9
Auto loss test (auto loss test and loopback loss test)
Chapter 11
Multi-core loss test
Chapter 12
IP test
Chapter 15
Fiber inspection probe (fiber end face check)
Chapter 14
Fault locator
Chapter 13
Visible light source
Section 8.2
PON_OPM (PON power meter)
1
Chapter 10
Multi-Core Fiber Meas (multi-core fiber measurement)
2
Chapter 16
OTDR Event Mapper
3
Chapter 17
1 AQ1200x/AQ1205x firmware versions 1.10 and later support this feature.
2 AQ1200x/AQ1205x firmware versions 2.01 and later support this feature.
3 AQ1200x/AQ1205x firmware versions 2.03 and later support this feature.
Chapter 2
Common Operations
