16-10
IM AQ1200-01EN
Procedure
Main View Screen
1.
Using the
rotary knob
and
ENTER
, select
Multi-Core Fiber Meas
. The following screen
appears.
The last measurement project appears.
If you are using this feature for the first time after purchase or if the settings have been initialized,
“NewProject” will appear. “NewProject” is an empty project.
Create a new project.
(See section 16.1.)
Confirm the waveform.
You can confirm the measured waveform.
You can check marker and event positions.
Project information
Displays project information
Set the wavelength.
You can select one of the wavelengths that have
been set in the measurement conditions or “All.”
The drive/folder name/project name of the current project
The number of cores whose measurement results have been saved
Preview area
Information about the core
number at the cursor location
Clear the check mark.
Clears the check mark or the pass/fail
judgment result indication from the cell at
the cursor location and deletes the cell data
Specifies skip
You can select this soft key when the
cell at the cursor location does not have
a check mark or the pass/fail judgment
result indication.
To cancel skipping, press this soft key again.
Core number
Core numbers set to Skip appear dimmed.
Using the arrow keys or the rotary knob, move the cursor to the
cell of a core number you want to measure.
Check mark indicating that the data has been saved or pass/fail judgment result indication
2.
Create a new project (see section 16.1), or load a previously saved project (see section 16.2).
The main view screen shows the measurement project.
3.
Using the
arrow
keys or the
rotary knob
, move the cursor to the cell of a core number you
want to measure.
4.
Press the
Wavelength
soft key to select the wavelength.
16.3 Measuring Multi-Core Fibers
