10-20
IM 701730-01E
Setting the Search Start Point
12.
Use
jog shuttle & SELECT
to set the search start point (Start Point box).
Set the search start point.
13.
Press
ESC
. The Setup dialog box closes.
Selecting the Window for Displaying the Searched Waveform (Zoom Waveform
Display Frame)
14.
The procedure is the same as step 12 on page 10-15.
Executing/Aborting the Search
15.
The procedure is the same as step 13 and 14 on page 10-15.
Redisplaying the Detected Waveforms
16.
The procedure is the same as step 15 and 16 on page 10-16.
Changing the Zoom Rate and Zoom Position of the Detected Waveforms
17.
Change the zoom rate and zoom position of the waveform according to the
procedures given in section 8.4.
Pulse Width Search
1.
Press
SHIFT+ZOOM (SEARCH)
. The SEARCH menu appears.
Selecting the Width Search Method
2.
Press the
Type
soft key. The Type menu appears.
3.
Press the
Width
soft key.
Setting the Search Condition
4.
Press the
Setup
soft key. The Setup dialog box opens.
Setting the Pulse Width Determination Type, Search Target Waveform, Level,
Polarity, Hysteresis, Pulse Width, and Search Start Point
5.
Use
jog shuttle & SELECT
to select the determination type (Type box).
6.
Use
jog shuttle & SELECT
to select the search target waveform (Source box).
7.
Use
jog shuttle & SELECT
to set the level for determining whether the polarity is
high or low (Level box).
10.4 Searching Waveforms Using the Search and Zoom Function
