3-4
IM 2560A-01EN
Note
• Condensation may form when the instrument is moved from a low temperature or humidity environment
to a high temperature or humidity environment, or when there is a sudden change in temperature. If
this happens, allow it to adjust to the surrounding temperature for at least an hour, and use it without
condensation. If you transport the instrument in its packing box, to prevent condensation, allow it to
adjust to the new ambient temperature for at least an hour before taking it out of the box.
• If the instrument has been stored in a hot-temperature, high-humidity environment, warm up the
instrument for at least a day before starting use.
Installation Orientation
Desktop
Install the instrument on a stable surface that is level in all directions and that is not slippery.
The supplied rubber stoppers can be attached to bottom legs of the instrument to prevent the
instrument from sliding. You can install the instrument in a tilted position using the movable legs.
However, if you attach the front rubber leg cap, you will not be able to stack the 2560A.
Movable legs
WARNING
• Do not adjust the movable legs in an unstable condition.
• Do not place the instrument in any position other than those shown in the above figures.
• Do not stack the instruments with the movable legs pulled out.
• Only one instrument can be stacked on top of another. Do not stack multiple instruments
on top of one instrument.
French
AVERTISSEMENT
• Ne pas manipuler les pieds escamotables lorsque l’instrument est instable.
• Ne pas placer l’instrument dans des positions autres celles indiquées ci-dessus.
• Ne pas empiler des instruments lorsque les pieds escamotables sont sortis.
• Seul un instrument peut être empilé sur un autre instrument. Ne pas empiler plusieurs
instruments les uns sur les autres.
Rubber leg cap
A9088ZM
Bottom leg
Note
If you attach the front rubber leg cap, you will not be able to stack the 2560A.
3.2 Installing the 2560A