Yingang YG48Q-5A, Руководство по обслуживанию, Страница: 104 / 144

YG48Q-5A Maintenance ManualFront wheel, front suspension device and steering stem
117
Disassembly and assembly of front wheel
Disassemble and assemble the front wheel according to
the following diagam.
After the bearing is removed, replace with a new bearing
along with dust seal.
While assembling the brake disc, apply small amount of
thread retaining adhesive LOCTITE243 on the threads of
the screw, with tightening torque being 20-30N.m.
Warning
The brake disc retaining screw must be coated
with thread retaining adhesive, with the tightening
torque being 20-30N.m. Otherwise, it may cause a
personal safety accident.
Front wheel spindle inspection
Place the front wheel spindle on the V-holder, and
measure the deflection of the wheel spindle with a dial
gauge; if the reading is no less than 0.2mm, replace the
front wheel spindle.
Front wheel bearing inspection
Place the front wheel on the calibration table, inspect the
rim’s deflection, and then manually rotate the wheel and
measure its deflection value with a dial gauge; if the
reading is no less than 2mm, replace the wheel bearing.
Front suspension device
Front suspension device
Removal of coverings) and front wheels (See Removal of
front wheel).
Remove the front mudguar and front license plate. Do not
scratch the outer decorating surface
Remove the front brake caliperand wire clip
Remove the wire clip and speed sensor
\
Dial indicator
Front brake caliper
Wire clip
Remove the front mudguard
Remove the front wheels
Rotate
it
Dial indicator