Yingang YG48Q-5A, Руководство по обслуживанию

Страница: 103 / 144

YG48Q-5A Maintenance ManualFront wheel, front suspension device and steering stem
116
To install the control subassembly
1) Installation is in the reverse order of removal. While
installing the brake cylinder body, make sure the
cylinder is in the same height as the original
mounting position to prevent air from entering the
main fuel cylinder, thus influencing the braking
performance. Do not twist the braking hose.
2) While installing, the clutch handle holder and the
front brake cylinder body notch shall be aligned with
the mark point of the grip tube, and the pins of
left/right combination switch shall be blocked into the
pin holes of the grip tube.
3) Steering column opening and a handlebar tube
positioning point alignment,, and fasten the bolt at
the connection board, and then the bolt at direction
of the tube, up to the torque of 20-30N.m.
4) Do not mount the throttle cable in the opposite
direction of the feeder on the right handle, otherwise
the handle may rotate incorrectly while refueling.
5) Upon installation, adjust the throttle control line.
Upon installation, check whether the cable and
wiring is in accordance with the wiring diagram.
Maintenance of wheel
To remove the front wheel
Support the motorcycle with a jack to lift the front wheel
above the ground.
Dismantle nut of front wheel axle and check it whether is
distored.
Unscrew the front wheel spindle and take it out.
Take out the front wheel. Lift the front fork as high as
possible while taking out the front wheel, to avoid
damaging the front mudguard.
To mount of the front wheel
While installing, fasten the front wheel spindle nut to the
required torque of 50-60N.m
Warning
The front wheel spindle must be firmly screwed up to
the required torque of 50-60N.m.