22.
23.
ASSEMBLY
Loosely thread the male bolt into the upper link
pivot pin on the frame. Do not overtighten.
Finish tightening the upper link pivot using a well
calibrated torque wrench set to 5 Nm
Torque to 5 Nm
Prep the main pivot axle with grease.
Slide the swing arm into place over the main pivot
sleeve on the front triangle.
05.
06.
08.
07.
ASSEMBLY
Slide the main pivot axle into the swingarm
through the non drive side. Using a Fox guide pin
to align the pivot sleeve slide the main pivot axle
through until it contacts the threads
Thread the main pivot axle in using a 10mm allen
wrench and torque to 9 Nm.
Torque to 9 Nm
Prep the lower link shock spacers with a small
amount of grease. This will help them stay in
place on the link.
Place the shock spacing washers against the
bearings on the inside of the link using the grease
to hold them in place.
09.
10.
11.
12.
