20.
21.
assembly
Make sure your tools are in good condition.
A worn allen key can round the hex on a bolt
not allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads. The instructions denote whether to
use a blue loctite compound or grease.
yeti tips
tools needed
Warning: service on Yeti bicycles requires special knowledge
and tools. Yeti cycles recommends that all service and
repairs be performed by an authorized Yeti Dealer
• Dead blow hammer
• Two - 5mm allen keys
• guide pin tool
• Grease
• Blue loctite
Press two 23.5mm reducers into the lower
portion of the shock.
Install the shock on the frame. Insert a 34.0mm
Ti female bolt through the drive side of the frame
for the shock. Prep an alloy male bolt with blue
loctite and tighten with two 5mm allen keys.
Torque to 90-95 in/lb.
Install the dogbone onto the frame. Insert a 40.5
mm Ti female bolt with washer through the drive
side of the frame and the dogbone. The fox guide
pin tool and a dead blow hammer can be used
help guide any female bolts through the frame
and its components. use an alloy male bolt
prepped with blue loctite on the non-drive side
and tighten with two 5mm allen keys.
Torque to 90-5 in/lb.
Align the shock and dogbone. Orient the lower
portion of the shock between the lower bearings
on the dogbone.
01.
02.
03.
04.
