horizont all y, approximat el y 1 m et er above t he ground.
2)
Otherwis e, the reel can use verti call y when you hang in an
overhead suitabl e beam or raft er
(Fi g.3).
3) The reel in t he l ower bracket
pin m ust be fixed with a bolt or
lock to s ecure the safet y. The
mounti ng bracket has 3 hol es, t o
the t wo hol es on bot h ends there is a M8 screw corresponds .
(You can als o fit all t he three hol es wit h s crews ). Each screw must be
with spring washer or paddi ng ( Fi g4). Position of th e t hree hol es
pleas e s ees Fi g.5 ( measurement in m m ) . Also, you can buy ex tra
bracket to move the unit t o m ore area while i n use.
3
.
ATTENTION POINTS FOR HOSE USE
The reel has a hi gh qualit y kink resi stant hos e s uppli ed.
1.
Aft er us e, pl eas e turn off th e ai r. In som e areas of hi gh t em perat ures,
the sunli ght wi ll heat the air hose, and cause it di ffi cul t to rewind.
2.
It is the best wa y to turn off the ai r before retracting the hos e.
3.
Do not leave t he reel in the out side during ver y l ow t em perature. Under
this conditi on, the hose ma y be less fl exible and di ffi cul t to retract.
4.
Do not touch an y chemi cal or subst ance, such as acet one, whi te s piri ts,
lacti c aci d et c.
4.
HOW TO LATCH AND RETRACT HOSE CORRECTLY
This reel is fitt ed with rat chet wheel and det ent desi gn, whi ch is eas y to
extend and ret ract t he hos e. When pull ing out the hose, you can hear
repeat ed “KADA” voice. When you pull out the hos e l ength needed and
hear “KADA ” voi ce, you can lat ch it ( Fi g.6, pi ct ure when the rat chet is in
use,V is the pull in g direction of hose). When you retract the hos e, pull out
about 265mm and when no “KADA ” voi ce , you can ret ract t he hos e now.
To retract, it is suggest ed that a minimum of 25% of
the hose has been extended. Duri ng retraction,
alwa ys hold the hose and foll o w t he ret raction until
it is finished. To prevent hurti ng person acci dent all y
or fra ying the hos e resul t from quick speed. If
needed, extend the hose t o full lengt h then allow
Fig.6
Fig.4
Fig.5
Fig.3
